7i77

From EuSurplusWiki
Revision as of 10:44, 21 May 2015 by Jtc (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


7i77 shop

Main caracteristrics
Up to 6 axis analog motion control card + I/O shop
Connected to the FPGA board though DB25 (standard 25 pins parallel port) shop
6 analog +-10V outputs
6 encoder input with index (differential or single ended)
32 inputs (5V to 32V)
  • all can read digital signals (5V to 32V)
  • 4 of those can be set up to read analog voltages with 8 bit resolution
  • 4 of those can be set up to read up to 2 MPG encoders
16 short circuit protected outputs (300mA max)
RS 422 interface for I/O expansion
When to use
When analog motion control is needed (your drives require a +-10V signal) and several inputs and outputs are used. In smaller machines, one 7i77 is enough to handle all motion and I/O control.
This card connects to
5i25 (Widely used)
6i25 (Widely used)
7i92
7i89db
7i76e
Cards that can be connected to this one
7i84
7i73
caption

Possible configurations

All possible (but not limited to) with all the following attached to this board (not requiring extra boards):

  • Up to 6 axis + several I/O + 32 inputs + 16 outputs
  • Up to 5 axis + 1 spindle (also analog frequency set up) + 32 inputs + 16 outputs
  • Up to 5 axis + 1 spindle (also analog frequency set up) + 30 inputs + 1 MPG + 16 outputs
  • Up to 5 axis + 1 spindle (also analog frequency set up) + 29 inputs + 1 MPG + 1 analog input + 16 outputs


Long description:

The 7i77 is daughtercard/breakout board for use with MESA's 25 pin I/O FPGA cards like the 5I25 or 6i25. The 7I77 is designed for interfacing up to 6 Axis of analog servo motor drives and also provides 48 isolated I/O points for general purpose field I/O use. Six +-10V analog outputs and six encoder inputs (all with index) are provided for servo interfacing. Six floating drive enable outputs allow control of active high or active low drive enables. Encoder inputs can be individually set for differential or single ended mode. 48 points of isolated field I/O are provided for general control use including limit switch and control panel inputs, coolant enable and tool changer control outputs. Isolated I/O includes 32 sinking inputs and 16 sourcing outputs. Inputs can sense 5V to 32V signals and the outputs can switch 5V through 28V signals. Maximum output load is 300 mA. Outputs are short circuit protected. In addition to the being able to read digital on/off status of each input, four input pin voltages are readable with 8 bit resolution, and two MPG encoder inputs are provided as an option on four field inputs. Field I/O is powered by an isolated 10-32V field power source. One RS-422 interface is provided for I/O expansion via a serial I/O daughtercard. All field wiring is terminated in pluggable 3.5 mm screw terminal blocks.

7i77 manufacturer manual